Power Stroke Fuel pressure regulator spring upgrade

 The GDS Fuel Pressure Spring differs from the stock spring in two ways. The first is in fuel pressure. It raises fuel pressure from the stock 60-80psi which usually comes out to be about 65psi, up to 90-110psi which usually comes out to be about 95psi. The second difference in the GDS and stock spring is in pressure loss due to cyclic fatigue. The stock spring loses about 25% of its spring tension in 10,000 cycles. The GDS spring loses about 1% to 5% of its spring tension in 1,000,000 cycles. Not bad for a $20.00 upgrade that can be installed in 15 minutes!

   Installation is simple and requires no special tools (except for a T-27 torques bit). You simply remove the pump cover pieces, and then remove the two T-27 torques screws on the driver’s side of the pump. Carefully separate the line from the pump and remove the spring (careful not to lose or damage the o-ring seal). Install the new spring making sure it seats properly, and button it back together; once again making sure that the o-ring gets or stays in its proper place.